STANDART PC/PC-VM WASTE WATER AND PROCESS PUMP


Descriptions

  • Domestic and industrial waste water, raw sewage, viscous and corrosive liquids, liquids with fibrous and solid substances.
  • Horizontal/Vertical, wide volute casing, single stage, end suction, centrifugal pumps with enclosed, semi-open or vortex type impeller.
  • 18 basic sizes covering wide range of operational area.
  • Due to the back-pull-out design, the complete bearing assembly including impeller and casing cover can be dismantled without removing the volute casing from the pipe system.
  • Bearing of PC type pumps are “life time grease lubricated” ball bearing up to 150-315 size. For bigger sizes oil lubricated ” ball bearings are used. In vertical design ( PC-VM ) always grease lubricated bearings are used.

Specifications

Discharge Flange : DN 40….DN 300 mm

Capacity : Up to 1600 m3/h

Head : Up to 95 m

Speed : Up to 2900 rpm

Operating Temperature : -100C up to +1100C

Casing Pressure ( Pmax ) : 10 bar ( 16 bar )

Material

Cast iron, ductile cast iron, stainless steel, duplex or bronze.

Shaft Sealing

Soft packing seal or mechanical seal.

Rotation

Direction of rotation is clockwise viewed fromdrive end.

Certification

EN ISO 9905, CE, ATEX, GOST-R

 

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Categories

LOKASI

Copy Protected by Chetan's WP-Copyprotect.