Flexible Joint U-Flex Type 2″

Flexible Joint U-Flex Type 2″ Tozen use for vibration absorption for equipment, such as pumps.

FEATURES

Multiple Feature
Composite material complement the feature of each other. Fluoropolymer liner for chemical and heat resistance, and rubber cover for vibration absorption.

Pressure Resistance
Besides the fluoropolymer liner, the tire cord withstanding internal pressure. Maximum design pressure is up to 1.6MPa. ( 16.3kgf/cm2), and a negative pressure of minus 0.086MPa. ( minus 650mmHg ).

Safety
The exterior rubber absorbs unexpected impacts and protection cover is not required for exposed applications.

Hot water supply line
Fluoropolymer liner with a maximum operating temperature up to 100⁰C. U-FLEX is suitable for hot water supply application without any contamination.

INSTALLATION Flexible Joint U-Flex Type 2″

Pump installation, such as hot water supply lines, chemical lines, and pure water lines.

DIMENSIONS AND ALLOWABLE MOVEMENTS

• Size : 2 Inch ( DN 50 mm )
• Dimension
  L : 104 mm
  Ød : 53 mm
  T : 25 mm
• Mass : 5.1 Kg
• Allowable Movement
  Eccentricity : 10 mm
  Elongation : 10 mm
  Compression : 10 mm
  Deflection angle : 10⁰
• Installation Tolerances
  Eccentricity : 4 mm
  Elongation : 3 mm
  Compression : 3 mm
  Deflection angle : 5⁰
• Mass is the data when material is SS400, and flange is JIS10K Flange
• Use a joint within the range of allowable displacement
• Fixing allowable dimension is included in allowable displacement ( allowable displacement = fixing time displacement + operation displacement ).
• Each displacement in chart are data of single displacement, so for multiple displacements, correction is necessary. For correction method, refer to ” Attention for handling or “TOZEN HP”
• Referring to ” Fixing bolt dimension table”, and use fixing bolt. Nut is not necessary. ( When companion flange is JIS10K, material is SS400, and when plain washer and gasket are not used ).