CENTRIFUGAL PUMP STANDART SKM use for handled Clean or slightly contaminated low viscosity liquids without solid and fibrous particles.
Descriptions
- Horizontal ring section, multistage, centrifugal pumps with closed impeller and diffuser
- 10 models from DN 32 up to 250 discharge flange diameter.
- In standard production, suction flange is placed on the right side and close to the coupling while discharge flange is at the other end and radially upwards ( R 3/0 ). If other flange position is required, it should be indicated in the order.
- Bearings of SKM type pumps are always grease lubricated.
Specifications
- Discharge Flange : DN 32……DN 250 mm
- Capacity : Up to 1000 m3/h
- Head : Up to 550 m
- Speed : Up to 2900 rpm
- Operating Temperature : 100C up to +1400C
- Casing Pressure ( Pmax ) : 25 bar ( 63 bar )
Material
Cast iron, ductile cast iron, stainless steel, duplex or bronze.
Shaft Sealing
Soft Packing seal or mechanical seal.
Rotation
Direction of rotation is clockwise viewed from drive end.
Certification
EN ISO 9905, CE, ATEX, GOST-R
