CET PUMP 35 CFM GAS provides a self contained, gasoline powered, ” slide-in” type compressed air foam system (CAF5) unit. The XAFS unit is designed to fit into the back of a standard length and width pick up truck body, to discharge water only, air only or compressed air foam from the same discharge outlet. In addition, the consistency of the compressed air foam ( expansion ratio ), wet/dry is fully adjustable.
Advantages of a CET 35 CFM GAS
- Class A foam allow faster fire suppression and extinguishment than plain water
- Foam clings to most surfaces and protects exposures much longer than plain water
- May Provide long term cost savings and may reduce property damage ( Class A Foam )
- Increase efficiency and conservation of water supply ( Class A Foam )
- Can be produced at a relatively low cost ( Class A Foam )
- Forms a protective blanket ( Class A Foam )
- Foam is visible during and after application
- CAFS attack lines are lighter than plain water hose lines
- Foam use may help to preserve evidence of fire cause
- Class A foam aids widland/urban interface attack.
Specifications
Engine
- 27 hp kohler gas engine at 3600 RPM
- 2 Cylinder, 4 stroke , air cooled
- 20 amp alternator
- 175 GPM @ 100 PSI
- Max. Flow 225 GPM
- Max Pressure 145 psi
- Single stage centrifugal pump
- Aluminum case with bronze impeller
- Direct Drive
- Stainless Steel piping
Compressor
- Oil injected piston type
- 35 cfm @ 125 psi
- Water cooled heads system
- Compressed air is cooled w/ water cooler
- Belt drive
CAFS System
- NFPA 125 gpm @ 35 cpm @ 125 psi
- 4 Outlet discharges 1″ or 1 1/2″
- Automatic balancing system
- 1″ tank fill line
- 2 1/2″ tank to pump, 2 1/2″ intake
- Air service line
Dimensions
- 34″ length x 44″ width x 26″ height
Weight
- 650 lb
