MULTISTAGE PUMP STANDART SKM-E


MULTISTAGE PUMP STANDART SKM-E use for handled liquid Clean or slightly contaminated low viscosity liquids without solid and fibrous particles.

MULTISTAGE PUMP STANDART SKM-E

Description

  • Horizontal ring section, multistage, centrifugal pumps with closed impellers and diffusers in end suction design.
  • 7 models from DN 40 up to DN 150 discharge flange diameter.
  • Discharge flange is on top for standard production, upon request different discharge flange positions can be produced.
  • Bearings of SKM-E type pumps are grease lubricated. Sleeve bearing used in the suction side is lubricated by the pumping liquid.

Specifications

  • Discharge Flange : DN 40…..DN 10 mm
  • Capacity : Up to 400 m3/h
  • Head : Up to 450 m
  • Speed : Up to 2900 rpm
  • Operating Temperature : -100C up to +1400C
  • Casing Pressure ( Pmax ) : 250 bar ( 63 bar )

Material

  • Cast Iron, ductile cast iron, stainless steel, duplex or bronze.

Shaft Sealing

  • Soft packing seal or mechanical seal.

Rotation

  • Direction of rotation is counter clockwise viewed from drive end.

Certification

  • EN ISO 9905, CE, GOST-R, ATEX

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Categories

LOKASI

Copy Protected by Chetan's WP-Copyprotect.