Sewage Pump STANDART C for wet installation are single stage, single entry, close coupled pump sets in non flameproof design
Depending on the hydraulic, end, the pump is intended to be used for pumping of :
- Domestic wastewater
- Sewage disposal
- Dirty and muddy water
- Industrial wastewater
- Rain water
- Ground water
Descriptions
- Domestic and industrial waste water, raw sewage, liquids with fibrous and solid substances.
- Vertical, wide volute casing, single stage, end suction submersible type centrifugal pump with enclosed, semi-open or vortex types impeller.
- 20 basic sizes covering wide range of operational area.
- Electric motor isolation class is IP 68
- In case of request motor cooling jacket is also applicable ( for pumps bigger than 30 kW ).
- Bearings of C Type pumps are “life time grease lubricated” ball bearings.
Specifications
- Discharge Flange : DN 50….. DN 300 mm
- Capacity : up to 1600 m/h
- Head : Up to 95 m
- Speed : Up to 2900 rpm
- Operating Temperature : Up to +40C
- Casing Pressure ( Pmax ) : 10 bar
Material
- Cast iron, ductile cast iron or stainless steel.
Shaft Sealing
- Mechanical Seal
Certification
- CE, GOST-R, TS 12599
