Single Tote Foam Trailer CET are ideal for use in industrial, commercial, municipal and forestry environments. Foam trailers provide a very effective tool for airport fuel storage and power plant installations.
Foam is needed for any fire or spill involving flammable or combustible solids or liquids.
- Water will not float on hydrocarbon products such as gasoline or diesel fuel.
- Water used on a fire in a contained area my sink, runoff or overflow
- Reduces toxic and flammable vapors given off by fuels
Why do you need foam?
Unit is to be installed on a double axle trailer.
- Heavy duty steel trailer w/steel floor
- Trailer to be painted red
- Plate form trailer dimension ti be 8′ long x 4′ between the fenders
- Tandem axles : 7,000 lbs
- Electric brake
- 7 pins trailer plug
- Sealed DOT LED lights
- 2-5/16″ ball attachment assembly
- Front jack w/7,000 lbs, capacity
- 2 rear 5 000 lbs, swivel downrigger stabilizers
- Two (2) steps, one each side, located on the front of each fender
Stripping
Side, Front and Rear DOT stripping shall be applied on each side of the trailer. DOT stripping will be red and white reflective stripes.
Foam Tote
The foam tote tank shall contain 265 (or 330) gallons of foam concentrate, measuring 48” x 40” x 46” high and shall be UV protected. The tote shall have two (2) opening: one (1) 6” on the top with cap and one (1) 2” ball valve outlet at the bottom. The tote shall have a pressure/vacuum vent on the top. The tote shall be protected by a tubular steel grid. The tote shall be DOT approved. The trailer shall have a quick and safety tote connector to replace empty tote by full tote. One (1) 265 (or 330) gallon bulk container tote shall be supplied empty.
4″ Water Manifold
All piping shall be stainless steel piping, painted red. The water inlet piping shall consist of a 4» manifold tube. The piping is secured on the front side of the platform of the trailer. The inlet overboard shall have two (2) 4” Storz connections with cap and chain, one (1) on each end of the manifold. One (1) 4” pressure gauge shall be tapped into the manifold tube and shall be easily readable from ground. One (1) 3/8” brass drain shall be tapped into the manifold
Two (2) Hose Trays
Two (2) hose trays made from 0.100” bright aluminum diamond plate, dimensions are 48” Long X 8” High X 12” Wide, shall be provided with canvas and net. Each compartment shall be capable of holding 200’ of 1-3/4” hoses. The compartments shall be installed over the wheel well, one (1) on the left (driver) side and one (1) right (passenger) side. The compartments shall be secured properly to the top of the wheel well.
General Warranty
CET warrants to the original purchaser that CET will, at its election, either replace or repair any part of the new equipment sold to the purchaser hereunder which has been given no abnormal use; and which has received proper maintenance; and which is determined by CET to be defective in material or workmanship; and which has, within one (1) year after delivery to the purchaser be returned at the purchaser’s expense, with transportation charges prepaid, to CET factory OR which has, within one (1) year after delivery to the purchaser, been pre-approved by CET for a third-party to perform the work. All problems shall be reported to CET in writing and damaged parts shall be returned to CET.
