Water Pump Standart SCP HT

Water Pump Standart SCP HT are specially designed for hot water and geothermal water application.

Water Pump Standart SCP HT


  • Horizontal, radially split volute casing type, single stage, end suction centrifugal pumps with closed impeller.
  • Heavy duty shaft not in contact with the medium handled ( dry shaft )
  • For casing sealing, confined gaskets are used to prevent blow-out under pressure.
  • Coupling misalignment due to thermal expansions are mainly reduced with centerline mounting design.
  • Due to the back-pull-out design, the complete bearing assembly including impeller and casing cover can be dismantled without removing the volute casing from the pipe system.
  • Bearings of SCP-HT type pumps are always oil lubricated.


  • Discharge Flange : DN 32 ….DN 250 mm
  • Capacity : Up to 1500m3/h
  • Head : Up to 160 m
  • Speed : Up to 2900 rpm
  • Operating Temperature : Up to +2300C
  • Casing Pressure ( Pmax ) : 25 bar ( 40 bar )


Ductile cast iron, steel, stainless steel or duplex.

Shaft Sealing

Soft packing seal or mechanical seal.


Direction of rotation is clockwise viewed from drive end.



Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *



Copy Protected by Chetan's WP-Copyprotect.